CCNA Network Simulator - Commands under review or update

[certforumz]

Commands under implementation:
1. show cdp neighbor detail (shows neighbors IP address without configuring TCP/IP)
2. DHCP configuration commands

note: CDP detects neighbor Cisco devices even without configuring TCP/IP. Therefore, appropriate changes are to be made to the show cdp neighbors command to display neighbor Cisco devices.

Example:

Router#show cdp neighbors

Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge

                 S - Switch, H - Host, I - IGMP, r - Repeater

Device ID        Local Intrfce     Holdtme    Capability  Platform  Port ID

lab-7206         Eth 0              157          R        7206VXR   Fas 0/0/0
lab-as5300-1     Eth 0              163          R        AS5300    Fas 0
lab-as5300-2     Eth 0              159          R        AS5300    Eth 0
lab-as5300-3     Eth 0              122          R        AS5300    Eth 0
lab-as5300-4     Eth 0              132          R        AS5300    Fas 0/0

Device ID: The configured ID (name), MAC address, or serial number of the neighbor device.

Local Intrfce: (Local Interface) The protocol being used by the connectivity media.

Holdtme: The remaining amount of time, in seconds, the current device will hold the CDP advertisement from a transmitting router before discarding it.

Capability
   
The capability code discovered on the device. This is the type of the device listed in the CDP Neighbors table. Possible values are:

R?Router
T?Transparent bridge
B?Source-routing bridge
S?Switch
H?Host
I?IGMP device
r?Repeater

Platform: The product number of the device.

Port ID: The protocol and port number of the device.